To install our Edge Grips is quick and easy.
Mark on your surface area where you will put your holes.
Now, drill a hole for each marked area (hole size is according to anchor type), and then insert your anchors into each hole.
After you put your anchors in you will want to take an Allen key and unlock the edge grip.
Remove the head of the edge grip and insert the Phillips flat head screw into the barrel and screw into your anchor.
You will now want to insert the heads back into the barrels (do not tighten down yet).
Now, place your material in the slots of the edge grips and push the head down until it is tight on your material.
Lastly, take your Allen key and tighten down the set screw to keep the heads tightly holding your material.
Once this is complete, wipe off any finger smudges on the standoff and stare in amazement at your completed project.